Spring Machine Forming Machine RX-60 RX-20A,RX-40A MX Series MCS-20 RS-8 AX Series MCS Series SX Series FX Series Coiling Machine PCX-40A PCX-20A PC-8A CS-8 CX-6A,CX-8,CX-15 CX-2A discontinued SCD-7 MCS-G series MCX series PC/PC-H Series SCD-5	Ultimate machine for the coiling of extremely fine wire make it debut! Computer Controlled Coiling Machine The CX-2A is optimized for the coiling of extremely fine wire; From 30 micron to 200 micron CX-2A The CX-2A provides the easiest and most precise way of coiling the very fine wire based on the newly developed Feed Unit and Servo Slides & the precise tool technology. CX-2A has 5 axes as standard; Feed axis, Cut axis, Diameter axis, Push Pitch axis, Arbor forward / backward axis. Feed Unit position can be adjusted Horizontally (Patent) The position of Feed Unit can be adjusted horizontally 15mm. When the relative position between the Feed Roll and the Wire Guide or the Length of the Wire Guide have changed, you can adjust the horizontal position of Feed Unit so that the front edge of Wire Guide is in contact with the Arbor. Servo Slides can be installed at any angle You can install the Servo Slide at any angle on the Slide Table according to the various way of coiling such as 1 or 2 point, the push pitch or the wedge pitch. (Servo Slide for One Point Coiling and Push Pitch are equipped as standard. Optional slide, tools, etc. are necessary for 2 Points Coiling.) Feed Roll Dia. is 20mm, Wire Guide Length is 10mm The most important point of coiling very fine wire is to make the Feed Roll Dia as small as possible and to make the Wire Guide Length between the Feed Roll and the Arbor as short as possible. Wire Guide has an integrated style The front end and back end of Wire Guide are integrated, thus the alignment of wire is very easy. Specification Machine Specification CX-2A Forming Capacity Wire Dia. 0.03-0.2mm Min. D/d 4 Outside Diameter 3.0mm max. Feed(2axes) Min. Increment 0.002mm Moter Power 50W Max. Speed 122m/min Cut Min. Increment 0.1 Moter Power 30W Outside Diameter Min. Increment 0.001 Moter Power 30W Push Pitch Min. Increment 0.001 Moter Power 30W Arbor forward/backward Min. Increment 0.001 Moter Power 30W Pneumatic Solenoid Valves 2pcs. Peripheral Device Control 16ports Power Requirement 3 Phase 10A Dimension Height 1626mm Width 1223mm Depth 964mm Net Weight 500kg Sample Computer Specification CPU Pentium Processor Program 2000 Steps Program Storange USB Flash Memory 3.5inch FDD Display 15inch TFT Color LC Display Operating Temp. 0 - 45 degree "Linux" is a registered trademark of Linus Torvalds of U.S.A. in U.S.A and other countries. Please note the contents of this web page is subject to change without notice.